AppForms

Margin Property

Shaji | Last Updated on : May 27, 2024

ClaySys AppForms V 1.0


Introduction

Each control in ClaySys AppForms had a property called Margin. This property can be used to change the margin of all four sides of the control.

Property Value

Even though the Margin is a single property it defines the property of all four sides of the control. If you see the default value in this property, it will be “0,0,0,0”. The margin values of all four sides are separated by a coma. The property value definition is “Left, Top, Right, Bottom”.

Please note that these values accepts even negative numbers. For example, if you like to move the control closer to another control, then you can use the negative values. This can also cause the control to be displayed under another control, so make sure you use the negative value properly.

Get Started with our Appforms Development Services
ShajiVice President of technology and services at ClaySys Technologies.
0 Comments

Leave a Reply

Your email address will not be published. Required fields are marked *